How to Reset a VSC Light in Seven Simple Steps

Summary

The VSC light on your car’s dashboard indicates there is a problem with the electronic stability system, which helps keep your car safely on the road in bad conditions.

When the VSC light is illuminated, it indicates a fault or issue with the system, which can affect your vehicle’s ability to maintain stability and control during maneuvers or in slippery conditions.

Before resetting your car’s VSC light, you should ensure all issues with the stability control system are addressed and diagnosed. The steps to reset a car’s VSC light include checking for issues, locating the OBD-II Port, connecting and powering on, scanning for code, etc. Learn about the VSC system here!

What is a Car VSC System? – Its Light and How it works

Now, let’s go deep to explain how to reset a VSC light in seven simple steps!

 

Here’s a step-by-step guide to help you reset the VSC light:

Contents

Check for Issues

Before resetting the VSC light, ensure no issues are causing the light to illuminate. Common causes include a loose gas cap, low tire pressure, or a faulty sensor. Diagnose and address any identified issues before resetting.

Locate the OBD-II Port

The VSC light can be reset using an OBD-II scanner. Locate the OBD-II port, usually found under the dashboard near the driver’s side. Plug the scanner into the port to start resetting.

Connect and Power On

Once connected, turn the ignition key to the ‘On’ position without starting the engine. This powers the scanner, allowing it to communicate with your vehicle’s onboard computer system.

vsc light and abs light

Scan for Codes

Use the scanner to scan for diagnostic trouble codes (DTCs) related to the VSC system. Note down any codes displayed as they may indicate issues affecting the VSC.

Clear DTCs

Navigate through the scanner’s menu to find the option to clear or reset DTCs. Select this option to clear the codes stored in the system, including those related to the VSC light.

Verify Reset

After clearing the codes, turn off the ignition key and disconnect the OBD-II scanner. Restart your vehicle to see if the VSC light remains off. If the issue persists, there may be an ongoing problem that requires further diagnosis.

Professional Assistance

If you’re unsure about performing the reset yourself or if the VSC light continues to illuminate after resetting, seek assistance from a qualified mechanic. They will conduct a thorough inspection using advanced diagnostic tools to detect and resolve the issue.

Bottom Line

Resetting a VSC light involves following the above steps to ensure your vehicle’s stability control system functions properly. That is all for this article, where I explained how to reset a VSC light in seven simple steps. I hope it was helpful, if so, kindly share with others. Thanks for reading, see you around!

Scroll to Top